Gecko AEWARE XM2 After power applied to board does not run self test repair in East Grinstead

AEWARE XM2 After power applied to board does not run self test repair cost

You can get your broken AEWARE XM2 PCB Board After power applied to board does not run self test repaired quickly and an estimate of cost will be provided within 30 minutes by your East Grinstead Gecko repair centre. Use our free estimate or repair option below to you use our Gecko repair services.

Electronic Partners provide local non-warranty PCB Board repairs in East Grinstead and other Gecko After power applied to board does not run self test repair services nationwide. Regardless where purchased, our qualified Gecko technicians offer a specialised expert PCB Board repair for all Gecko models such as the Gecko AEWARE XM2.

Authorised Gecko After power applied to board does not run self test Repairs in East Grinstead

• 

• • 
    Date :
    
  • 
    10/01/2026
    
  • 
    City :
    
  • 
    East Grinstead, United Kingdom
    
  • 
    Device :
    
  • 
    Gecko AEWARE XM2
    
  • 
    Category :
    
  • 
    Gecko Repairs & Service East Grinstead
    
  • 
    Problem :
    
  • 
    This board is fitted to a Hydropool hot tub. After a power cut the board does not go through it's self test. When you look at the display on the XM2 with the control panel connected it is flashing and displaying random segments and flickering. If the control panel is disconnected it stops and is stable. This issue started intermittantly and has got progressively worst over time. In the past after a few resets the bord has settled down and then runs perfectly until the next time there is a power cut. I also had an Intouch 2 remote module attached to this and had to disconnect it as that was also not functioning correctly, it would randomly change the status of the economy mode or change the heat settings. There does not appear to be any damage to the unit.
    

Repair Cost and Process For Gecko Repairs in East Grinstead

1) Request your Free Estimate to get the maximum price for your Gecko AEWARE XM2 After power applied to board does not run self test repair or request our PCB Board repair service and receive a free prepaid post label within minutes for your Gecko AEWARE XM2 repair in East Grinstead.

2) Use the store finder on the bottom of our page to find our authorised Gecko service centre East Grinstead and drop off your PCB Board.

3) If received, our Gecko experts diagnose your PCB Board, proceed and fix your PCB Board After power applied to board does not run self test once the repair cost is confirmed.

4) No prepayment is required for any of our After power applied to board does not run self test repair services. We will Invoice you conveniently once we repaired your Gecko PCB Board. You can pay your bill online, and we will return your Gecko AEWARE XM2 as it was new.

Most of our Gecko PCB Board services come with a minimum of three-month warranty. It can be extended to a one year warranty for complete peace of mind and customer satisfaction.

Therefore, in conclusion, there is no reason to buy a new PCB Board. Especially if we can fix your Gecko, AEWARE XM2 After power applied to board does not run self test at a fraction of the cost of purchasing it new. The cost to fix a PCB Board start for most models at £22.

Most Recent PCB Board Repair Requests