No Idea No Idea PCB is causing connected host device to Hard shut down when powered repair in Rochdale

No Idea PCB is causing connected host device to Hard shut down when powered repair cost

You can get your broken No Idea PCB Board PCB is causing connected host device to Hard shut down when powered repaired quickly and an estimate of cost will be provided within 30 minutes by your Rochdale No Idea repair centre. Use our free estimate or repair option below to you use our No Idea repair services.

Electronic Partners provide local non-warranty PCB Board repairs in Rochdale and other No Idea PCB is causing connected host device to Hard shut down when powered repair services nationwide. Regardless where purchased, our qualified No Idea technicians offer a specialised expert PCB Board repair for all No Idea models such as the No Idea No Idea.

Authorised No Idea PCB is causing connected host device to Hard shut down when powered Repairs in Rochdale

• 

• • 
    Date :
    
  • 
    07/01/2026
    
  • 
    City :
    
  • 
    Rochdale, United Kingdom
    
  • 
    Device :
    
  • 
    No Idea No Idea
    
  • 
    Category :
    
  • 
    No Idea Repairs & Service Rochdale
    
  • 
    Problem :
    
  • 
    Hello,
    I am enquiring about the feasibility of diagnosing and repairing a PCB from an astronomy camera, in case you are able to support this type of work.
    Device: ZWO ASI071MC Pro (cooled CMOS astronomy camera)
    Board type: Main power / control PCB
    Location: United Kingdom
    Fault description:
    The camera causes an immediate shutdown of any host device it is connected to via USB (laptop or ASIAIR). This occurs even when the TEC (cooler) module and sensor/camera head are completely disconnected, and only the main PCB is powered.
    During investigation, I measured approximately 12 V present on the USB VBUS line, which strongly suggests a failure in the onboard power management or protection circuitry, likely allowing back-feeding from the 12 V rail into the USB supply. This behaviour is repeatable and independent of external power supplies (multiple known-good PSUs tested).
    Because the fault persists with all downstream loads disconnected, I am confident the issue is localised to the PCB itself rather than the TEC or sensor assembly.
    What I am looking for:
    An assessment of whether PCB-level diagnosis and repair would be feasible
    Likely repair scope (e.g. DC-DC regulator, power-path control
    

Repair Cost and Process For No Idea Repairs in Rochdale

1) Request your Free Estimate to get the maximum price for your No Idea No Idea PCB is causing connected host device to Hard shut down when powered repair or request our PCB Board repair service and receive a free prepaid post label within minutes for your No Idea No Idea repair in Rochdale.

2) Use the store finder on the bottom of our page to find our authorised No Idea service centre Rochdale and drop off your PCB Board.

3) If received, our No Idea experts diagnose your PCB Board, proceed and fix your PCB Board PCB is causing connected host device to Hard shut down when powered once the repair cost is confirmed.

4) No prepayment is required for any of our PCB is causing connected host device to Hard shut down when powered repair services. We will Invoice you conveniently once we repaired your No Idea PCB Board. You can pay your bill online, and we will return your No Idea No Idea as it was new.

Most of our No Idea PCB Board services come with a minimum of three-month warranty. It can be extended to a one year warranty for complete peace of mind and customer satisfaction.

Therefore, in conclusion, there is no reason to buy a new PCB Board. Especially if we can fix your No Idea, No Idea PCB is causing connected host device to Hard shut down when powered at a fraction of the cost of purchasing it new. The cost to fix a PCB Board start for most models at £22.

Most Recent PCB Board Repair Requests