Synology DS1815+ Not booting repair in Bromsgrove

DS1815+ Not booting repair cost

You can get your broken DS1815+ PCB Board Not booting repaired quickly and an estimate of cost will be provided within 30 minutes by your Bromsgrove Synology repair centre. Use our free estimate or repair option below to you use our Synology repair services.

Electronic Partners provide local non-warranty PCB Board repairs in Bromsgrove and other Synology Not booting repair services nationwide. Regardless where purchased, our qualified Synology technicians offer a specialised expert PCB Board repair for all Synology models such as the Synology DS1815+.

Authorised Synology Not booting Repairs in Bromsgrove

• 

• • 
    Date :
    
  • 
    16/06/2024
    
  • 
    City :
    
  • 
    Bromsgrove, Worcestershire
    
  • 
    Device :
    
  • 
    Synology DS1815+
    
  • 
    Category :
    
  • 
    Synology Repairs & Service Bromsgrove
    
  • 
    Problem :
    
  • 
    I have two units with the exact same problem. Both DS1815+ will not power on. Both already have the 100 ohm resistor fix applied. Both have been tested with a short between the green and black wires (due to a likely Q4 transistor failure) and I can get as far as a flashing power light. I have ruled out the memory as the cause of the problem. I have tested the resistor which was already applied to these boards and they show as 100 ohm. The1k ohm fix has not been applied to either but I believe that the wire short should allow the boot. These were purchased thinking that I could apply the 100 ohm resistor fix and both initially worked when I applied the short to ground fix between green and black wires from the PSU. Note that while one board is immaculate the second board had extensive liquid damage and I had removed much internal corrosion by hand before powering on.
    

Repair Cost and Process For Synology Repairs in Bromsgrove

1) Request your Free Estimate to get the maximum price for your Synology DS1815+ Not booting repair or request our PCB Board repair service and receive a free prepaid post label within minutes for your Synology DS1815+ repair in Bromsgrove.

2) Use the store finder on the bottom of our page to find our authorised Synology service centre Bromsgrove and drop off your PCB Board.

3) If received, our Synology experts diagnose your PCB Board, proceed and fix your PCB Board Not booting once the repair cost is confirmed.

4) No prepayment is required for any of our Not booting repair services. We will Invoice you conveniently once we repaired your Synology PCB Board. You can pay your bill online, and we will return your Synology DS1815+ as it was new.

Most of our Synology PCB Board services come with a minimum of three-month warranty. It can be extended to a one year warranty for complete peace of mind and customer satisfaction.

Therefore, in conclusion, there is no reason to buy a new PCB Board. Especially if we can fix your Synology, DS1815+ Not booting at a fraction of the cost of purchasing it new. The cost to fix a PCB Board start for most models at £22.

Most Recent PCB Board Repair Requests